High Point Gutter
Call 425-449-6622 Get a Free Estimate

Gutter Replacement, Guards, and Repair in Redmond, WA

Redmond has two kinds of houses, and their gutters fail in different ways. The ramblers and split-levels on Education Hill, Grass Lawn, and Idylwood went up in the 1960s and 70s under evergreens that are now twice as tall. The planned neighborhoods out on Redmond Ridge, Union Hill, and Bear Creek went up in the 1990s and 2000s with builder-grade gutters that are now 20 to 25 years old. High Point Gutter has been replacing, covering, and repairing both kinds since 2016.

Each service has its own in-depth page: gutter replacement and new installs, Alu-Rex gutter guards, and repairs for sagging or leaking gutters. Below is how that work plays out across Redmond.

Valley Floor or Plateau: It Changes the Job

Downtown Redmond sits almost flat on the Sammamish River valley floor. Up on Education Hill, and farther east on Redmond Ridge and Union Hill, homes sit a few hundred feet higher. That difference shows up on the roof.

On the plateaus, winter storms bring a little more rain and a better chance of snow and ice. A gutter hung on widely spaced or worn-out hangers can bend under that weight in a single cold snap. Down in the valley, the problem is where the water ends up. Wet ground drains slowly, so a downspout that dumps next to the foundation keeps the soil soaked for days after the rain stops.

Across all of it, Redmond is heavy evergreen country. Douglas fir, cedar, and hemlock shed needles and small debris year round, not just in the fall.

Where We Work in Redmond

Education Hill. Established homes on generous lots under some of the tallest trees in town. Needle load is heavy, and many original systems are undersized for the roofs they serve.

Overlake. Mid-century houses near the tech campuses, surrounded by new townhomes and apartments near the light rail. The older homes tend to need replacement. The newer buildings mostly need guards and outlets that keep up.

Grass Lawn. Quiet streets of 1970s and 80s homes around Grass Lawn Park. This is classic replacement territory: seams that weep, corners that drip, and gutters that have lost their pitch over forty winters.

Idylwood. Homes near Lake Sammamish and Idylwood Park, many on shaded, sloping lots. Gutter covers and careful downspout routing do most of the work here.

Downtown and Old Redmond. Older valley-floor houses mixed in with dense new mixed-use buildings. Drainage at the bottom of the downspout matters as much as the gutter itself.

Redmond Ridge. A master-planned community whose original gutters are reaching the end of their life all at once. Neighbors often replace within a few years of each other, and matching the existing color and profile keeps the street consistent.

Union Hill. Larger lots and custom homes on the plateau, with long rooflines and deep tree cover. These roofs often call for 6-inch gutters, extra downspouts, and covers rated for fine needles.

Bear Creek. Wooded neighborhoods northeast of town with homes from the 1980s and 90s. Enough age for fascia and hanger problems, enough trees for constant needle drop.

Redmond Jobs From Our Records

Every one of these comes from our own job history in Redmond.

Full Replacement With Covers. A complete tear-off and a new 6-inch narrow-bead fascia-style system, finished with Double Pro Gutter Covers so the new gutters stay clear under the trees.

Partial 6-Inch Replacement. Only one section of the house had failed, so we replaced that run with 6-inch K-style gutter and left the sound runs in place.

Four-Building Apartment Tune-Up. Gutter tune-ups across four buildings of a Redmond apartment community, with rotted fascia replaced along the way.

Gutters Reattached. A run that had pulled away from the house, rehung and secured on a home where the rest of the system was worth keeping.

Warranty Re-Slope. Water was sitting in a run after an install. We came back under warranty, re-sloped it, and it drains the way it should.

Builder Installs. Fascia-style gutters in white, and downspouts in a custom color, on new Redmond homes for local builders.

What We Do in Redmond

Gutter Replacement & Installation. Seamless gutters formed on site, sized to the roof, and color-matched to the house or the neighborhood. We replace just the failed runs when that makes sense. Gutter replacement in Redmond.

Gutter Guards & Covers. T-Rex Gutter Covers and Double Pro Gutter Covers from Alu-Rex. Double Pro Gutter Covers are the usual pick under Redmond firs and cedars because they are built for fine debris. Redmond gutter guards.

Gutter Repair. Bent runs after a snow load, pulled hangers, leaky seams, and downspouts that dump at the foundation. Redmond gutter repair.

Why Redmond Homeowners Choose High Point Gutter

A Short Drive Away. Our Woodinville office sits just up the Sammamish River valley, so Redmond is part of our regular Eastside routes.

Certified Alu-Rex Master Installer. The top distinction Alu-Rex gives an installer, with a lifetime warranty on the Alu-Rex covers we install.

We Come Back. Our work carries a 10 year workmanship, 20 year manufacturer's warranty, and our Redmond job records include the return visits to prove it. See our warranties page.

Licensed, Bonded & Insured. License #HIGHPPG841J1. Every Redmond job is fully covered.

Free, No-Pressure Estimates. An estimator comes out, looks at the whole system, and tells you what it needs. No obligation.

600+ Google Reviews. Rated 4.9 across our Google listings.

Free Inspection

BOOK YOUR FREE INSPECTION

Schedule a free on-site gutter inspection. We climb up, find the real problem, and give you an honest plan.

Book Now

FREQUENTLY ASKED QUESTIONS

If the house was built in the late 1990s or 2000s, those gutters are 20 to 25 years old, which is about when builder-grade systems start to go. Watch for dripping seams and corners, gutters that hold water, hangers backing out of the fascia, and runs that bent under snow. Our estimator can tell you whether you need a full replacement or just a few runs.
Yes. Our seamless gutters come in a wide range of colors, and we match the existing color and profile so the new system blends in with your house and the rest of the street. If your HOA has written guidelines, send them over before the estimate and we will quote to them.
If your gutters are in good shape, covers can often go right on them. If they are close to the end of their life, it usually makes more sense to replace the gutters and add covers in one visit. We will tell you which applies to your house.
Yes. We have done gutter tune-ups and fascia replacement across multiple buildings at a Redmond apartment community. Property managers can request one estimate for the whole site.
Call us and we come back. Our work carries a 10 year workmanship warranty, and in Redmond that has meant return visits to re-slope a run or clear a downspout at no charge.

From Our Portfolio

Recent Projects in Redmond

Real projects on real Puget Sound homes.

Commercial Gutter Repair in Redmond, WA: A Four-Story Apartment Building Tune-Up, and Why the Downspouts Kept Blowing Off

Project Spotlight

Commercial Gutter Repair in Redmond, WA: A Four-Story Apartment Building Tune-Up, and Why the Downspouts Kept Blowing Off

Downspout crosspieces on a four-story Redmond apartment building had no screws, so wind kept blowing them off. High Point fastened…

Read More →
Gutter Cleaning in Redmond, WA: Moss in the Gutters, a Brushed Roof and a Moss Treatment Around Solar Panels

Project Spotlight

Gutter Cleaning in Redmond, WA: Moss in the Gutters, a Brushed Roof and a Moss Treatment Around Solar Panels

A repairs call on a Redmond home turned into a one-visit cleaning: moss-filled gutters cleared, the roof brushed, and a…

Read More →
Gutter Guard Installation in Redmond, WA: Gutter Clean Pro on a Modern Home’s Black Gutters, After a Reslope and New Flashing

Project Spotlight

Gutter Guard Installation in Redmond, WA: Gutter Clean Pro on a Modern Home’s Black Gutters, After a Reslope and New Flashing

A modern Redmond home's black gutters were resloped, two were lowered for new black flashing, and 94 feet of Gutter…

Read More →
Gutter Repair in Redmond, WA: Resloping 34 Feet of Needle-Filled Gutter and Resealing Three Corners

Project Spotlight

Gutter Repair in Redmond, WA: Resloping 34 Feet of Needle-Filled Gutter and Resealing Three Corners

Needle-packed gutters on a Redmond home got a full cleaning, 34 feet of reslope, three resealed corners and two downspouts…

Read More →
Gutter Replacement in Redmond, WA: A Repair Call That Found No Drip Edge, Answered With 103 Feet of New 5-Inch Gutter

Project Spotlight

Gutter Replacement in Redmond, WA: A Repair Call That Found No Drip Edge, Answered With 103 Feet of New 5-Inch Gutter

A repair call on a Redmond home found no drip edge, so High Point replaced 103 feet of gutter and…

Read More →
View All Projects