High Point Gutter
Call 425-449-6622 Get a Free Estimate
← All Posts

Bellevue Gutter Repair: Counter Flashing and a Valley Diverter

October 5, 2026

Gutter corner with debris on the existing covers and an open gap at the roof edge before repair in Bellevue, WA

Home › Projects › Bellevue Gutter Repair

High Point Gutter repaired the gutter edge on a two-story home in Bellevue, WA 98008 on October 1, 2026. There was a gap between the roof edge and the gutter, so we installed 22 feet of counter flashing and a valley diverter, then removed and treated the moss on the roof and cleaned off the existing gutter covers. See more projects in Bellevue.

LocationBellevue, WA 98008
ServiceGutter repair with moss removal and treatment
PropertyTwo-story home with an asphalt shingle roof, a brick chimney and existing gutter covers
Counter flashing22 linear feet
Valley diverter1
Moss workManual moss removal, then a zinc sulfate monohydrate treatment
Also includedDebris cleaned off the existing gutter covers
Project investment range$1,000 to $1,300
DatesAssessed September 16, repaired October 1, 2026

What we found

At the September 16 assessment, the gutters already had covers, and leaves and needles were sitting on top of them. There was also an opening between the shingles and the back of the gutter, which we call a light gap: water coming off the roof can run through it and behind the gutter instead of into it.

Gutter corner with debris on the existing covers and an open gap at the roof edge before repair in Bellevue, WA
The opening at the roof edge, September 16.

At one roof valley, the concentrated flow from two slopes was hitting a short stretch of gutter. Moss was growing between the shingle courses, and branches had collected on one slope.

Moss growing along the shingle courses of a roof before treatment
Moss holds water against the shingles.

What we recommended

The gutters did not need replacing; the problems were the gap and one valley, so we recommended a targeted gutter repair. Counter flashing tucks behind the existing drip edge and closes the gap. A valley diverter is a small metal backboard on the gutter where the valley drains, so fast water drops in instead of shooting over.

The work

On October 1 our technician installed the 22 feet of counter flashing and the valley diverter, then cleaned the debris off the covers. The moss came off in two steps: brushed off by hand, including around the chimney, then treated with white powdered zinc sulfate monohydrate along the ridges and upper courses. The treatment keeps working after the visit as the moss dies and rain washes it away over the following weeks.

White zinc sulfate moss treatment applied along the ridges of an asphalt shingle roof in Bellevue, WA
The white residue is normal and rinses off with rain.

Cost

Project investment range: $1,000 to $1,300. This range reflects the scope of this completed project and is not a current quote. Counter flashing is priced by the foot and this house needed only 22 feet; heavier moss takes more labor.

Related questions

Do gutter covers stop water from getting behind the gutter?

No. Covers keep debris out of the trough, but an opening behind the gutter is a separate problem. This house had covers and still needed counter flashing.

Is moss treatment the same as moss removal?

No. Removal is hand work with a brush. The zinc treatment is a powder that keeps working after the visit as the remaining moss dies off.

About this project

This project documentation was prepared by High Point Gutter from the job records and photos from our crew, October 2026. Technical review by Ben Metsker, Manager, High Point Gutter.

High Point Gutter provides gutter repair in Bellevue and across the Greater Seattle Area. See more projects in Bellevue, or read about gutter replacement if your system needs more than a repair.

Daylight between your shingles and gutter?

We can look at the roof edge and tell you whether counter flashing will close it. Request a free inspection or call High Point Gutter at (425) 449-6622.