Home › Projects › Bellevue Gutter Repair
High Point Gutter repaired the gutter edge on a two-story home in Bellevue, WA 98008 on October 1, 2026. There was a gap between the roof edge and the gutter, so we installed 22 feet of counter flashing and a valley diverter, then removed and treated the moss on the roof and cleaned off the existing gutter covers. See more projects in Bellevue.
| Location | Bellevue, WA 98008 |
| Service | Gutter repair with moss removal and treatment |
| Property | Two-story home with an asphalt shingle roof, a brick chimney and existing gutter covers |
| Counter flashing | 22 linear feet |
| Valley diverter | 1 |
| Moss work | Manual moss removal, then a zinc sulfate monohydrate treatment |
| Also included | Debris cleaned off the existing gutter covers |
| Project investment range | $1,000 to $1,300 |
| Dates | Assessed September 16, repaired October 1, 2026 |
What we found
At the September 16 assessment, the gutters already had covers, and leaves and needles were sitting on top of them. There was also an opening between the shingles and the back of the gutter, which we call a light gap: water coming off the roof can run through it and behind the gutter instead of into it.

At one roof valley, the concentrated flow from two slopes was hitting a short stretch of gutter. Moss was growing between the shingle courses, and branches had collected on one slope.

What we recommended
The gutters did not need replacing; the problems were the gap and one valley, so we recommended a targeted gutter repair. Counter flashing tucks behind the existing drip edge and closes the gap. A valley diverter is a small metal backboard on the gutter where the valley drains, so fast water drops in instead of shooting over.
The work
On October 1 our technician installed the 22 feet of counter flashing and the valley diverter, then cleaned the debris off the covers. The moss came off in two steps: brushed off by hand, including around the chimney, then treated with white powdered zinc sulfate monohydrate along the ridges and upper courses. The treatment keeps working after the visit as the moss dies and rain washes it away over the following weeks.

Cost
Project investment range: $1,000 to $1,300. This range reflects the scope of this completed project and is not a current quote. Counter flashing is priced by the foot and this house needed only 22 feet; heavier moss takes more labor.
Related questions
Do gutter covers stop water from getting behind the gutter?
No. Covers keep debris out of the trough, but an opening behind the gutter is a separate problem. This house had covers and still needed counter flashing.
Is moss treatment the same as moss removal?
No. Removal is hand work with a brush. The zinc treatment is a powder that keeps working after the visit as the remaining moss dies off.
About this project
This project documentation was prepared by High Point Gutter from the job records and photos from our crew, October 2026. Technical review by Ben Metsker, Manager, High Point Gutter.
High Point Gutter provides gutter repair in Bellevue and across the Greater Seattle Area. See more projects in Bellevue, or read about gutter replacement if your system needs more than a repair.
Daylight between your shingles and gutter?
We can look at the roof edge and tell you whether counter flashing will close it. Request a free inspection or call High Point Gutter at (425) 449-6622.

